Verification of a Three-Dimensional Model of Delaware Bay
A three-dimensional numerical hydrodynamic model of Delaware Bay is being developed to assess the impact of deepening the navigation channel from near the mouth of Delaware Bay to the...

Design of Manning's-Rougness-Coefficient Study in New York State
Field-collected hydraulic data can be used to compute roughness coefficients for channels with different hydraulic characteristics. Suggested criteria for the design of a roughness-coefficient...

Study of Friction Factors in the Upper Reaches of the Rio Grande
The purpose of this study is to investigate the determination of Manning's roughness in the upper Rio Grande river basin and compare results to other studies where Darcy Weisbach friction...

Roughness Coefficients for High-Gradient Channels in New York State
Manning's roughness coefficients (n values) were computed for a range of flows at six streams in New York State (USA) that have high energy gradients (greater than 0.002) and large median...

Streamflow Related to Channel Geometry in Northern New England
Channel geometry measurements can be used to estimate various streamflow characteristics at ungaged stream locations. Channel cross section dimensions and sediment size distributions were...

Sediment Modeling in the Rio Grande Conveyance Channel
The Rio Grande Conveyance Channel and the Rio Grande Floodway convey water from the San Acacia diversion dam to Elephant Butte Reservoir. The Conveyance Channel was built in early 1950's...

Development of Long-Term Three-Dimensional Hydrodynamics in Long Island Sound for Use in Water Quality Modeling
The Blumberg-Mellor (1987) three-dimensional hydrodynamic model has been adapted by the National Oceanic and Atmospheric Administration's National Ocean Service (NOS) to provide hydrodynamic...

Revenue Enhancement for Water and Wastewater Systems
This proceedings, Revenue Enhancement for Water and Wastewater Systems, examines techniques used in the water and wastewater utility industry...

Estimating Network Model Parameters from Mail Survey Data
Network models are generally based on a four-step modeling process; trip generation, trip distribution, modal split, and trip assignment. Microcomputer implementations of these steps have...

Data Base for Seismis Rick Assessment in Mexico City
We describe a model to estimate expected ground motions and expected damage, based on intensity damage relations derived for 14 classes of buildings representative of Mexico City construction....

Techniques for Seismic Rehabilitation of Buildings in Mexico City
The 1985 earthquake in Mexico City caused collapse or damage of a large number of engineered buildings. After this event several hundreds of buildings were retrofitted using several techniques....

Passive Energy Dissipation Systems for Earthquake-Resistant Design
Passive energy dissipation devices, also known as supplemental damping devices, have been proposed as a means by which the earthquake resistance of a building can be substantially enhanced,...

Built-Up Compression Members for Noval Structural Systems
This paper discusses built-up compression members used in novel structural systems for two high-rise buildings: InterFirst Plaza at Dallas Main Center and Columbus Center in New York....

Landslide Stabilisation at the Clyde Power Project, New Zealand
The Clyde Power Project is a hydro electric development on the Clutha River in the South Island of New Zealand. A wide range of stabilization measures have been used to treat several large...

Modeling Gas and Brine Migration for Assessing Compliance of the WIPP
The U.S. Department of Energy (DOE) is developing the Waste Isolation Pilot Plant (WIPP) in southeastern New Mexico as a facility for the long-term disposal of defense-related transuranic...

Heat and Vapor Transport Beneath an Impermeable Cap
Vadose-zone moisture transport near an impermeable barrier has been under study at a field site near Albuquerque, NM since 1990. Moisture content and temperature have been monitored in...

The Waste Isolation Pilot Plant (WIPP) Integrated Project Management System
The Waste Isolation Pilot Plant (WIPP), located 26 miles east of Carlsbad, New Mexico, is a research and development project of the Department of Energy (DOE), tasked with the mission...

Stochastic Modelling of Groundwater Flow at the WIPP Site
A stochastic approach to modelling the groundwater flow in the vicinity of the WIPP site in New Mexico is described. A geostatistical model of the transmissivity of the Culebra dolomite...

Natural, Cultural, & Environmental Resource Values Influencing Colorado River Basin Management
The Colorado River Basin supplies water to the seven western states of Wyoming, Colorado, Utah, Arizona, New Mexico, Nevada, and California, and to Mexico. Originally the Colorado River...

Water Use Pattern of Residential and Commercial Customers
The availability of the Automatic Meter Reading (AMR) devices make it possible to read a large number of meters in a short period of time. Through the use of AMR, we monitored weekly water...

 

 

 

 

Return to search